COLOR ADHESION MORTAR EPS is used for gluing Styrofoam panels on mineral substrates made of concrete and a minimum of 2 months old, bricks, plaster, Ytong, Salonite and other substrates. It is also used as a mortar for laying a glass mesh on thermal insulating panels (panel reinforcement) and as a mass for final surface processing (smoothening) before applying a decorative plaster.


COLOR ADHESION MORTAR has great application characteristics, it is elastic and vapour-permeable.


Prior to application of COLOR ADHESION MORTAR EPS, the substrate should be even, firm, dry, clean and free of frost. Mix the contents of the 25 kg bag with approximately 6 liters of water and stir the mass manually or with an electric mixer until it becomes homogeneous. Allow the mixture to rest for about 10 minutes and then stir again.
Apply COLOR ADHESION MORTAR EPS to the edges of the panel in strips, and to the center of the panel in dots. Then press the panel on the suitably prepared substrate. After 2 days, apply COLOR ADHESION MORTAR EPS on the glued panels with a notched trowel in a thickness of 2 – 3 mm. In the freshly applied adhesive mortar, press sheets of glass mesh so that they overlap by 10 cm. After 24 hours, apply another layer of adhesive mortar and smoothen. After 2 – 5 days apply primer for plaster COLOR GRUND on the prepared substrate, followed by COLOR ACRYLIC PLASTER or COLOR SILICONE PLASTER after 24 hours.


Packaging units:

25 kg

Consumption calculation

Enter the square meters for quick calculation:

* Consumption is calculated per one coat.
  • exterior surfaces
  • water resistance and vapour permeability
  • protection against weather influences (sun, rain, snow)
  • resistant to abrasion and impact
surface preparation dry, firm, cleaned
application notched trowel
drying Bonding: 2 – 3 days
Reinforcement: 2 days
Smoothening: 2 – 5 days
consumption Bonding:
4.0 – 5.0 kg/m²
Reinforcement and processing: 5.0 – 6.0 kg/m²
storage from +5 °C
to +35 °C